Personal Project; Entry for the 9/09/2015

3D Print Test

 My first 3D print of my beadt but it didnt print out too well and lost its bottom jaw chain and tail and some of the spines.

 so as an artist i just created my own.

 I painted it black to hide the rough join marks but think i may need to make a few coats in between sands to get it smoother.

House Painting

 Some painted vines growing down the dark alley.

 Not too many more walls to paint... getting there.

 The alley walls all painted, Just have to do the cobblestones and the roofs.

 Detail of the door. A pen was used to score the tree marks in the door

 Added some spooky trees to the gallows set.

 These have been painted black and then dry brushed.

Small model shrubbery was added to give some variance in the plant life.

Street Lamps

 Use chopsticks from lunch time meal that i just ate.... mmmm
Chop just about 4-5 cm above the square end of the chopsticks.

 Find some old Christmas lights, pull out the yellow bulbs. Then use a circle cutter to cut a circle in some paper. Use a pin to widen the hole then a skewer then the bulb to fit it correctly.

Use some super glue to glue a strip of paper around the join where the light meets the bamboo to hide the join. try not to get glue on fingers as when you don't realize its stuck your finger gets embedded into the piece, see above(white spot).

 Put another piece around the bottom and  now its ready for painting.